Internal throttle grip kit

Motorcycle Throttle Grip Inside Open
For 1" Handlebars

Open style and will also accept bar end turn signals like Kellerman and others with 13 mm diameter.

These grips accept all rubber, plastic and aluminum grips with an 1-1/8” ID.

The open end version allows for the installation of bar end turn signals and features an additional inner brass tube to protect the turn signal wire from damage from the plunger.

Overview of Product:
• Be ready for a revolution!

• Unique : 6 main bearings with four ball bearings and two sleeve bearings.

• Precise : with a precision of hundredths of a millimeter milled for minimum clearance.

• Incredibly easy :
• Thanks to a special Bowden even at extreme Z-arms and APE Hangern absolutely smooth.

• Enjoy ultimate comfort AND a wireless optics.

• Because there are hotter Eyecatcher as disturbing Cables!

• And no one wants, like an ox to pull the gas to move from the spot.

Features:
• TÜV Approved

• Exceptionally smooth.

• Sophisticated technology - applied for a utility model.

• For aluminum and rubber grips with an 1-1/8” ID. (28,5 mm)

• For all 1 "handlebars with cable gland.

• Supplied with 135cm Special Bowden cable can be cut to desired.

• Step-by-step instructions.

Important note !:
The original right grip can not be used!

Right-side handgrips w/ cable routing must be replaced with left-side grips.

You'll need 2 sets grips where you only can use the left ones.

Tips for installation:
• We recommend that the installation be performed by a specialist workshop!

• For workshops and experienced hobbyist, we offer a special mounting kit on.

• Thus cutting off the handlebars and the placement of holes will be much easier.

• See internal throttle mounting kit.
( ABS Partnumber 015040 )